Card Swipe Installation - Bay-Tek Skee-Ball Classic 22 Service Manual

The Skee Ball game is pre-wired with a UCL (Universal Card Link) connector to accept Card Swipe
systems from many different manufactures.
Please follow these instructions to make full use of this capability.
To CE18009 & CE18010
cables from Power
Distribution Board.
This provides 12 VDC
and Ground (Com)
This plugs into the I/O Aux Board
This provides 12 VDC
and Ground (Com)
This plugs into the I/O Aux Board
Game Adjustments:
Enter game menu, Set "Set Credits" to 1 (1 Credit per play), Set "Credit Type" to Swipe, or Tap
Set "Game Mode" to Tickets.
On the I/O Aux Boards, set dipswitches #5 and #8 to ON. (Disables low ticket input)
Notes:
- Many card swipe systems have a voltage threshold that can be adjusted in the card swipe menu.
Please set this "Game Drive Threshold" to 2 Volts.
- The Bill Acceptor harness can also be used as an alternative to provide a coin-in signal to the game.
Cable part # AACE18008: White wire is signal, Black wire is ground (common).
Danger: Red wire is 12VDC

CARD SWIPE INSTALLATION

AACE18014
AACE18014
AACE18014
AACE18014
This would normally plug
into coin mechanism.
Option #1:
Card swipe systems may come with a
standard 9 pin Molex connector.
This is the UCL connector.
Simply plug this connector into your card
swipe reader.
Option #2:
If your card swipe systems does not have a
standard 9 pin Molex connector, then you will
have to splice wires into the AACE18014 harness.
Red wire is +12 Volts DC
Green wire is coin signal
Black wire is ground (common)
9