Bay-Tek HOT SHOT FREE THROW FURY Manual page 17

- Locate and slide 2 Ramp Braces into the slots as
shown, but DO NOT screw down yet.
- Remove the next board from the pallet stack. This
board has notches cut out that will align with the tabs on
the Ramp Braces.
- Using 2 people, place this board into the cabinet as
shown. Ensure the tabs line up with the notches.
- Locate 8 of 2" bugle screws (A5SCFH060) from the
hardware kit.
- Push the floor board snug to the rear of the cabinet and
screw the 8 screws from the top down into the support
braces into the pilot holes locations using a # 2 bit.
- Locate 16 of black 10's screws from the hardware kit.
- Carefully crawl under cabinet and secure the 2 ramp
braces using these 16 black screws with a # 2 bit.
A5SCPH152
17