Card Swipe Installation - Bay-Tek CONNECT 4 HOOPS Service Manual

CARD SWIPE SYSTEM INSTALLATION
The Connect 4 Hoops game is pre-wired with a UCL (Universal Card Link) connector to accept Card
Swipe systems from many different manufactures.
Please follow these instructions to make full use of this capability.
Option #1:
Card swipe systems may come with a standard 9 pin Molex
connector. This is the UCL connector.
Simply plug this connector into your
card swipe reader.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE10014 & AACE10015 harness.
Notes:
1.) Many card swipe systems have a voltage threshold that can be adjusted in the card swipe
menu. Please set this "Game Drive Threshold" to 2 Volts.
2.) There are ticket dispenser extension cables located in the left side coin door if needed.
Menu Changes
Enter menu, go to "Payout" Menu
Change "Credits" to 1
Change "Swipe Prompt" to "Enabled"
Go to "Game Settings" Menu
Set "Game Mode/ Payment" to desired option
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
AACE10015
AACE10015
27
This would normally plug
into coin mechanism.
AACE10015
AACE10014
12 Volt DC Power from
Power Dist. Board
AACE10015
AACE10014
12 Volt DC Power from
Power Dist. Board