Scoring Issues - Bay-Tek HOT SHOT FREE THROW FURY Manual

Information on Scoring:
There are 2 reflective sensors mounted on the back of the hoop.
The game must "see" both of these sensors to score a basket.
It must first see the top sensor, then the bottom sensor. This sequence eliminates the "false score".
The infrared light from the sensors bounce off the reflective tape in the front of the hoop and creates a
beam. The ball will break this beam to score.
AASE22000P
Top Hoop Sensor
Red Housing
AASE22001P
Bottom Hoop Sensor
Blue Housing
When beam is operating correctly, both the yellow and green LED's will glow on right side of sensors.
If only the yellow LED is ON, then the beam is not being reflected back at the sensor.
Check Reflective tape (AATA8701)
Ensure the housing assembly is pointing straight at reflective tape.
If no LED's are ON, then sensor is not getting power.
Check cables AACE22033P and AACE22004P
Replace sensor. (AASE22000P or AASE22001P)
Note: There is a small pot on the sensor itself that controls brightness.
If this is turned up too far, the sensor will be too bright and overpower the
other sensor.

SCORING ISSUES

57
AATA8701 is the
reflective tape.