Bay-Tek HOT SHOT FREE THROW FURY Manual page 75

Install Front and Top Platforms:
- Locate the front and top platforms and bring to the game. These
will be installed on top of the wood supports in the space between
the 2 games.
Important! In order for these platforms to clear the white plastic
attached to the games, you will have to push the rear of the game in
toward the other game. This will open up the front end enough so
the wood can be slid in.
The tabs on the lower platform must slide into the holes
on the top platform.
- Locate 2 of 1-1/2" bolts (A5SCPP025)
from hardware kit.
- Install the 2 of A5SCPP025 into these 2 far holes in the top platform
using a Phillips screwdriver bit.
- Locate 7 of 2" screws (A5SCFH060) from hardware kit.
- Screw the 7 screws into the remaining holes in the top platform
using a # 2 square bit.
- Locate 2 of 2" screws (A5SCFH060) from hardware kit.
- Screw the 2 screws into the lower edge of the lower platform as
shown using a # 2 square bit.
Installation is now complete! Pull the rear of the game to
re-straighten the games to their final position.
A5SCPP025
A5SCFH060
A5SCFH060
75