Table of Contents
Advertisement
- Locate the Back Wall Splice previously removed from
the box.
- Install Back Wall Splice at the top back of game over 2
long bolts as shown.
- Locate 2 washers and 2 nylon nuts from the hardware
kit. A5WAFL060 and A5NUNY065.
A5WAFL060
- Install a washer and locknut on top of the long bolts and using a 7/16"
wrench -
but do not fully tighten yet.
easier installation of the Back Wall Panel later.
- Remove the next board from the pallet stack and set aside for later use.
Install the right side cage to the back of game:
- Remove the wood bracing to access the Side Cages using
a # 2 square bit.
- Remove a net section (all 6 are the same) from the pallet stack and
bring to the right side of the cabinet.
- Bring one 15 foot ladder to the outside right rear corner of the game.
- Bring a "Little Giant" 8 foot ladder to the inside of the game.
We recommend the "Little Giant" because one leg can be extended to
accommodate the slant of the bottom of the ball area.
- Locate 3 of bolts (A5SCHH007) and 3 nuts
(A5NULO050) from the hardware kit.
- Using 2 people, bring the net section to the right rear of the cabinet.
- Install the 3 bolts (A5SCHH007) from the front side net into the back wall red
metal. Have the 2nd person behind the game to thread on the 3 nuts
(A5NULO050). Tighten using a 5/32 hex bit.
A5NUNY065
Leave this board slightly use for
A5SCHH007 A5NULO050
21
Advertisement
Table of Contents
