Card Swipe Installation - Bay-Tek Hyper Nova Service Manual

CARD SWIPE SYSTEM INSTALLATION
The Hypernova game is pre-wired with a UCL (Universal Card Link) connector to accept Card Swipe
systems from many different manufactures.
Please follow these instructions to make full use of this capability.
Option #1:
Card swipe systems may come with a standard 9 pin Molex
connector. This is the UCL connector.
Simply plug this connector into your
card swipe reader.
Note:
- Many card swipe systems have a voltage threshold that
can be adjusted in the card swipe menu. Please set this
"Game Drive Threshold" to 2 Volts.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE23011 harness.
Menu Changes
Enter menu, scroll to "Credit" Menu
Verify "Credits" set to 1
Scroll to "Card Swipe" Menu
Verify set to "1"
Check dipswitches on the I/O Aux Board in the front of game. Verify Dipswitch # 5 ON
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
AACE23011
AACE23011
15
This would
normally plug
into coin
mechanism.
AACE23011
This would
normally plug
into coin
mechanism.
AACE23011