Table of Contents
Advertisement
CARD SWIPE SYSTEM INSTALLATION
The Lil Ticket Monster game is pre-wired with an UCL (Universal Card Link) connector to accept Card
Swipe systems from many different manufacture's.
Please follow these instructions to make full use of this capability.
Option #1:
Card swipe systems may come with a standard 9 pin Molex
connector. This is the UCL connector.
Simply plug this connector into your
card swipe reader.
Note:
- Many card swipe systems have a voltage threshold that
can be adjusted in the card swipe menu. Please set this
"Game Drive Threshold" to 2 Volts.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE26013 harness.
Menu Changes
Enter menu, go to "Payout" Menu
Verify "Credits" set to 1
Verify "Card Reader" set to "Enabled"
Check dipswitches on the I/O Aux Board in the front of game. Verify Dipswitch # 5 ON
AVAILABLE BLANKING PLATES
A5PL4200 DBA Plate for 12V Upstacker Bill Acceptor
A5PL8900 Plate used for Bill Validator
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
AACE26013
AACE26013
A5PL9998 Plate used instead of Coin Mechanisms
A5PL9995 Plate used instead of ticket dispenser
13
AACE26013
Power In
from Power
Distribution
AACE26013
This would normally plug
into coin mechanism.
AACE26013
Power In
from Power
Distribution
Board
AACE26013
Board
Advertisement
Table of Contents
