Card Swipe Installation - Bay-Tek Big Bass Wheel Service Manual

CARD SWIPE SYSTEM INSTALLATION
Careful installation is required during card swipe installation to avoid 12 volt wires from possibly touching
signal lines.
Card swipe cable may plug directly into the UCL connector at the coin door.
Note: A separate power supply is recommended for Big Bass Wheel to supply 12 volts to the card
system.
If the game does not pay out the correct tickets, definitely install a separate power supply to power
card system inside game.
Option #1:
Card swipe systems should come with a standard 9
pin Molex connector.
Simply plug this connector into your card swipe reader.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE1609 harness.
Menu Changes
Enter menu, Set "Credits Per Game" to 1(swipe)
Notes:
1.) Many card swipe systems have a voltage threshold that can be adjusted in the card swipe menu.
Please set this "Game Drive Threshold" to 2 Volts.
Blank plate instead of Coin Door is part # A5PL9998
This is the UCL connector.
From Ticket Dispenser
Blue Wire is Notch Signal
White Wire is Enable Signal
Black wire is ground. (common)
AACE1609
AACE1609
12
Green wire is coin signal.
Red wire is +12 Volts DC
AACBL4A-DOOR
Coin Switches and Lights
Black wire is ground. (common)
Green wire is coin signal.
Red wire is +12 Volts DC
AACBL4A-DOOR
Coin Switches and Lights