Bay-Tek HOT SHOT FREE THROW FURY Manual page 29

Install the Backboard:
The inside back of the backboard has an angle cut in the white
plastic that will match up with an angle an the back of the game.
This will allow the backboard to be lifted up and hooked into
place.
- Using 2 or more people, carefully carry the Backboard inside
the cabinet, lift over the plywood angled board and set into
position as shown.
- Locate 6 bolts (A5SCPH270) from the hardware kit.
- Install the 6 bolts using a # 2 square bit. 1 bolt in each
corner, and 2 near the basket.
Connect the Backboard Cables:
- Locate 6 of Wire Saddles (A5WRSD010) from the
hardware kit.
- Locate the bag of 3 long cables from inside the
Front Console.
(CE22032, CE22033, CE22034)
- Uncoil these 3 cables and bring the ends labeled "2nd end" to
the top back of the game.
- Plug the CE22032 cable into the hoop
sensors SE22000 and SE22001 cables.
Ensure that the red connectors plug together,
and the blue connectors plug together.
A5SCPH270
29