Bay-Tek HOT SHOT FREE THROW FURY Manual page 47

TROUBLESHOOTING GUIDE
Problem
Game not coining up
No Sound
Controller Board
creates sound, the
Audio Amplifier board
amplifies it.
I/O Aux Board Issue
Game does not coin up,
and has no other
functions.
Red and
Yellow
LEDs
Tickets are empty in ticket tray
Low Tickets
message on
Faulty cable. Disconnected,
monitor
loose or broken wires.
Faulty low ticket switch.
Dipswitch on I/O Aux Board.
Faulty I/O Aux Board.
Probable Cause
Look for communication and
power on the I/O Aux Board
for that player.
Ensure game makes sound
when coin switch is triggered.
Ensure 12 Volts DC is at coin
door.
Game set to large amount of
credits per game.
Coin Input stuck ON
Volume/Attract
volume set to zero.
Disconnected, loose
or broken wires.
Verify 12 Volts DC to
Audio Amplifier
Boards on CE22012P
Faulty speaker.
Green power LED should be
flashing.
Red and Yellow LED's should be
on solid, with yellow LED blinking.
Faulty I/O Aux Board.
Refer to "I/O Aux Board Issue"
diagnostic section.
Check coin switches—both should be wired
normally open. If one switch is "closed" the other
will not work either. Check wiring to I/O Aux
Board.
(AACBL4A-DOORA, CE22017P)
12 Volts DC comes in from Power Dist Board on
cable # CE22017P
Check Game Setup Menu. Ensure Credits is set
to proper value.
Ensure only 5 volts on coin switch green and
black wires. Replace I/O Aux board if needed.
Part # AACB9605A-HSHOT2
Enter Main Menu and verify:
Game Volume & Attract Volume is not OFF.
Refer to wiring diagram. Check connections and reseat audio
cable from controller board to speakers. Cables # A5CE2321,
A5CEAU010, CE22000P, and power in cable CE22012P
Unplug audio cable (A5CEAU010) from motherboard, plug
into MP3 player or phone and see if music is amplified and
comes out of speaker.
If Yes - then controller board is faulty.
If No - then cable or amplifier board is faulty
Replace speaker. AACE8811A
If it is off, then check 12 & 5 Volts DC coming
into board on cable CE22007P from Power
Distribution Board.
If not on, then it is not communicating with the
controller board. Check A5CBL5900 USB
cable. Replace cable if needed.
If they are off, check power into board on
CE22007P cable. Replace board if needed.
Replace if needed.
Part # AACB9605A-HSHOT2
Load tickets into tray. Ensure tickets hold down the micro
switch wire.
Check connectors from low ticket switch to Door board.
Check for continuity. (AACE22016P)
Inspect switch and replace if needed. (AASW200)
Check dipswitch settings on the I/O Aux board. If the game
has a card swipe system, Dipswitch # 5 should be ON.
Replace I/O Aux Board. Part # AACB9605A-HSHOT2
47
Remedy