Bay-Tek HOT SHOT FREE THROW FURY Manual page 72

- Install the Lower Plexi as shown with 2 bolts & nuts on the
top on bottom, and 3 bolts & nuts on each side, and tighten
using a # 2 square bit.
Build Top Plexi Assembly:
- Locate the Top Plexi (#A5DE22025)
- Locate 2 of long side metal (A5ME22019)
- Locate 6 of Divider Connection Plates (A5ME22022)
- Locate 8 of bolts (A5BOPH312) and 8 nuts (A5NULO050) from
the hardware kit.
- Place the plexi upside down on a flat surface.
- Slide the long side metal under the edge of the plexi.
- Position 3 of the divider connection plates under the long side
metal.
- Align the 4 holes in the plexi and long side metal and install the 4
bolts & nuts into the holes, making sure to include the diver
connection plates on those 3 holes.
Tighten using a # 2 square bit.
- Repeat this process for the other edge of the top plexi.
A5NULO050
A5BOPH312
72