Bay-Tek HOT SHOT FREE THROW FURY Manual page 39

Install final red metal Ball Guard:
- Locate the Ball Guard (A5ME22017) and bring to
game and place as shown.
- Locate 4 of bolts (A5SCHH007) and 4 nuts
(A5NULO050) from the hardware kit.
A5SCHH007 A5NULO050
- Install 2 of bolts (A5SCHH007) and 2 nuts (A5NULO050) into the left side, and install 2 of
bolts (A5SCHH007) and 2 nuts (A5NULO050) into the right side. Tighten using a 5/32 hex bit.
The game build is now complete!
- Locate the power cord (A5CORD29). It will come out from
the right back of front console. Remove the 7 screws using a
# 2 square bit to access the line filter socket which the power
cord will plug into.
- The power cord should then be plugged into the wall socket.
- Open the front door of the game and flip the rocker switch
on the power strip to power on the game.
The game is now set up and ready to play!
Enter the menu to adjust settings to your specific location.
Price per play / Ticket Payout / etc..
If your lucky enough to have 2 games, go to the beginning and start over.
If you also have a Divider Kit, the games should be left about 18 inches apart to provide room
for the kit to be installed. Assembly Instructions for the Divider Kit will be included in the kit.
39