Bay-Tek HOT SHOT FREE THROW FURY Manual page 32

Install Floor Trim:
- Locate the rolled up foam and laminate floor.
- Locate 2 packs of black plastic trim
- Locate 30 of 1-1/2" screws (A5SCFH125) from the
hardware kit.
- Roll out the white foam so that it is flush with the
backboard with equal distance gaps on the left and right
side.
- Roll out the laminate flooring on top of the white foam so
that it is flush with the backboard with equal distance gaps
on the left and right side.
- Place 1 of the longer black plastic trim pieces against the
back wall and secure with 5 of 1-1/2" screws (A5SCFH125)
Do not overtighten - these screws only need to be snug.
- Pull the laminate flooring tight toward the front of the cabinet.
- Place 1 of the shorter black plastic trim pieces against the
rear left side wall and secure with 5 of 1-1/2" screws
(A5SCFH125)
Again -do not overtighten - these screws only need to be snug.
- Place 1 of the shorter black plastic trim pieces against the
rear right side wall and secure with 5 of 1-1/2" screws
(A5SCFH125)
- Place 1 of the shorter black plastic trim pieces against the
front left side wall up against the previously installed piece and
secure with 5 of 1-1/2" screws (A5SCFH125)
- Place 1 of the shorter black plastic trim pieces against the
front right side wall up against the previously installed piece
and secure with 5 of 1-1/2" screws (A5SCFH125)
The last longer black plastic trim piece will hold down the front
edge of the laminate and foam.
- Line up the black plastic piece so that it is flush against the
edge of the laminate & foam.
- Secure with 5 of 1-1/2" screws (A5SCFH125)
A5SCFH125
32