Bay-Tek HOT SHOT FREE THROW FURY Manual page 15

- Remove the next board from the pallet stack and place on the
floor as shown.
- Locate 2 sets of bolts, spilt washers, and
washers from the hardware kit.
A5BOHH090
- Unwrap one of the packages of Short Legs
part # A5ME22008 and place one against the
right middle side wall as shown.
- Hand thread the bolt, split washer, washers into right side wall
and tighten using a 9/16" wrench.
- Tip this right middle wall section up and bring to assembly.
- Locate 6 black bolts from the hardware kit.
- Using 2 people, place the right middle section into position as
shown.
Note: The sides have interlocking
tabs that lock the sides into
Place.
- Hand thread the 6 bolts into the holes of the
connection plate.
- All 12 of these bolts can now be tightened using
a # 2 square bit.
A5WALO010
A5WAFL050
A5BOPH312
15