Card Swipe Installation - Bay-Tek Piano Keys Service Manual

CARD SWIPE SYSTEM INSTALLATION
The Piano Keys game is pre-wired with a UCL (Universal Card Link) connector to accept Card Swipe
systems from many different manufactures.
Please follow these instructions to make full use of this capability.
Option #1:
Card swipe systems may come with a standard 9 pin Molex
connector. This is the UCL connector.
Simply plug this connector into your
card swipe reader.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE13014 harness.
Notes:
- Many card swipe systems have a voltage threshold that can be adjusted in the card swipe
menu. Please set this "Game Drive Threshold" to 2 Volts.
Menu Changes
Enter menu, go to "Payout" Menu
Verify "Credits Per Play" set to 1
Verify "Swipe Prompt" set to "Enabled"
Go to "Game" Menu
Set "Redemption Type" to desired option
Check dipswitches on the I/O Aux Board in the front of game. Verify Dipswitch # 5 ON
Please contact Baytek Games if any further questions. (920) 822-3951 Ext. 1102
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
AACE13014
AACE13014
12
This would normally plug
into coin mechanism.
AACE13014
AACE13014
12 Volt DC Power from
Power Dist. Board
AACE13014
AACE13014
12 Volt DC Power from
Power Dist. Board