How To Adjust The Ball Gate - Bay-Tek HOT SHOT FREE THROW FURY Manual

HOW TO ADJUST THE BALL GATE

If the ball gate is not opening fully, or blocking balls when it is open,
the metal motor mount must be adjusted up or down.
This ball gate motor mount is covered by a black plastic panel.
Remove this panel by removing the 11 screws using a
# 2 square bit.
Verify the ball gate opens and closes cleanly and is set to the correct
height to stop balls:
To test - Press the menu button to enter the main menu.
Press menu button to get to "Diagnostic", then press the menu
select button to scroll to the Gate Diagnostics.
Press the right Versus Head to Head Button to lower the gate.
Press the left Single Player Button to raise the gate.
If any adjustments need to be made for the ball gate
height, loosen the 2 bolts holding the assembly to the
wood using a 7/16" wrench.
Re-position the assembly in the appropriate direction and
re-tighten the bolts.
Test again using the menu buttons in the diagnostic menu.
When the ball gate height is correct, the black plastic
cover can be attached to the bottom of the game.
This will protect the wires and motor from curious fingers.
Slide the thin black plastic panel into position under the
cabinet, sliding the notches into the wood.
Secure the panel using the 11 screws using a # 2 square
bit.
59