Bay-Tek HOT SHOT FREE THROW FURY Manual page 23

Install the left side support to the back of game:
- Locate the 2 Back Wall Supports (C) part # A5ME22005 from giant
heavy box and place near the assembly area.
- Locate 3 of bolts (A5SCHH007) and 3 nuts (A5NULO050) from the
hardware kit.
- Install 1 of the interchangeable Back Wall Supports (C) on the left side
of the game, to the net wall - above the back wall as shown using the 3
bolts and nut. Tighten using a 5/32 hex bit.
Install the right side support to the back way the same way:
- Locate 3 of bolts (A5SCHH007) and 3
nuts (A5NULO050) from the hardware kit.
- Install the Back Wall Supports (C) on the right side of the game, to the
net wall - above the back wall as shown using the 3 bolts and nuts.
Tighten using a 5/32 hex bit.
The Back Wall Panel previously removed from the pallet
stack will now be installed to the back of the game:
Position the 2 ladders behind the game so that
2 people can carry the Back Wall Panel up the
ladders and slide it into the gap between the red
metal brackets and the bare wood back wall
splice.
Note: Make sure the bare wood piece is slightly
loose to allow the Back Wall Panel to slide in.
A5SCHH007 A5NULO050
A5SCHH007 A5NULO050
23