Table of Contents
Advertisement
CONTROLLER BOARD INFORMATION
The controller board has 3 red LED's that show
good power into the board.
If one of these LED's is not red, check the
corresponding voltage on the CE22013P cable
from the Power Distribution Board into Controller
Board.
There should be 5 Volts DC between the red and
black wires.
There should be 12 Volts DC between the yellow
and black wires.
The 3.3 Volts DC is regulated by the Controller
Board itself. If this LED is out, replace the
Controller Board. Part # AACB22000A
The green LED's on the Controller show USB
communication with the Door Board, and the Ma-
trix Board.
There should be 2 of these 4 LED's on at all
times.
If not, then one of those USB devices is not
working properly.
Swap USB ports on the Controller Board to rule
out a faulty USB port.
Both games need the cross over linking cable plugged into the
"Link" socket on the controller Board.
Cable # CE22036P
Make sure it is not a straight through cable.
Verify Linked in the games menu:
Enter the menu, and scroll through the options by pressing
the "Menu Select" button.
Both linked games must be in this menu option.
Both "P" and "G" are normally "OFF"
The "P" will change to "ON" when the other games Single Player button is pressed.
The "G" will change to "ON" when the other games Head to Head button is pressed.
LINKING ISSUES
61
Advertisement
Table of Contents
