Bay-Tek HOT SHOT FREE THROW FURY Manual page 27

Repeat this same process for the front set of side cages:
- Locate 5 of bolts (A5SCHH007) and 5 nuts
(A5NULO050) from the hardware kit.
- Using 2 people, remove a net section from the
pallet stack and bring to the right side of the cabinet.
Since the side nets are interchangeable, there will be some extra holes not used.
We recommend using 2 bottom holes, 1 middle hole, and 2 top holes for each
side net as shown.
- Install the 5 bolts (A5SCHH007) from the middle side net into the rear side net.
Thread on the 5 nuts (A5NULO050). Tighten using a 5/32 hex bit.
Secure bottom edge of cage:
- Locate 6 of black 10's (A5SCPH152) from the
hardware kit.
- Install the 6 black 10's (A5SCPH152)
using a # 2 square bit into the L brackets on
the bottom of the nets.
Repeat the process for the left side net
section:
- Bring a net section to the left side of the cabinet.
- Locate 5 of bolts (A5SCHH007) and 5 nuts (A5NULO050) from the
hardware kit.
- Install the 5 bolts (A5SCHH007) from the middle side net into the
rear side net. Thread on the 5 nuts (A5NULO050). Tighten using a 5/32 hex bit.
- Locate 6 of black 10's (A5SCPH152) from the hardware kit.
- Install the 6 black 10's (A5SCPH152) using a # 2 square bit into the
L brackets on the bottom of the nets.
1 Roof Panels will now be installed on top of the front nets:
\
- Locate the last Roof Panel board previously removed from box.
- Locate 4 black bolts from the hardware kit.
- Install the Roof Panel on top of side nets.
Ensure T-Nuts are on top of board.
- Hand thread 2 bolts into each side of each Roof Panel.
(It's best to keep the T Molding splice toward the back of the game)
- Tighten all bolts using a # 2 square bit.
A5SCHH007 A5NULO050
A5SCPH152
A5BOPH312
27
A5SCHH007 A5NULO050
A5SCPH152