Bay-Tek HOT SHOT FREE THROW FURY Manual page 16

Repeat the same process for the left side middle side:
- Remove the next board from the pallet stack and
place on the floor.
- Locate 2 sets of bolts, spilt washers, and washers
from the hardware kit.
- Unwrap one of the Short Legs part # A5ME22008
and place one against the left middle side wall.
- Hand thread the bolt, split washer, washers into left side wall
and tighten using a 9/16" wrench.
- Tip this left middle wall section up and bring to assembly.
- Locate 6 black bolts from the hardware kit.
- Using 2 people, place the left middle section into position.
- Hand thread the 6 bolts into the holes of the connection plate.
- All 12 of these bolts on the left side can now be tightened
using a # 2 square bit.
- Locate 1 Leg Support (G) part # A5ME22009
- Locate 4 bolts from the hardware kit.
- Place the Leg Support into position as shown (It's best to
keep the open end toward the back of the game) and
secure using these 4 black bolts using a 5/32 hex bit.
The assembly so far:
A5SCHH007
A5BOHH090
A5BOPH312
16
A5WALO010
A5WAFL050