Bay-Tek HOT SHOT FREE THROW FURY Manual page 28

Prepare the Backboard:
- Remove the plywood with Backboard attached from Pallet #1
using # 2 square bit.
- Using 2 or more people, remove a backboard section from the
pallet stack and set on the floor.
- Remove the 4 nuts from the plywood using a 7/16" wrench.
- Remove the 4 bolts the front of the Backboard using a # 2
square bit.
- Important! From the back side of Backboard, tuck the cables
into the hole so they will not be pinched as the Backboard is
installed. Make sure they are secure as the Backboard is moved.
28