Bay-Tek HOT SHOT FREE THROW FURY Manual page 19

We will now build the front sides. It is the same process as before, noting that the arrows on
the wood sides point towards the rear of the cabinet.
- Remove the next board from the pallet stack and place on the floor.
- Locate 2 sets of bolts, spilt washers, and
washers from the hardware kit.
- Unwrap one of the Short Legs part # A5ME22008 and place one
against the left front side wall.
- Hand thread the bolt, split washer, washers into side wall and tighten using a 9/16" wrench.
- Remove the next board from the pallet stack and place on the floor.
- Locate 2 sets of bolts, spilt washers, and
washers from the hardware kit.
- Unwrap one of the Short Legs part # A5ME22008 and place one
against the right front side wall.
- Hand thread the bolt, split washer, washers into
side wall and tighten using a 9/16" wrench.
- Bring both front side walls to the cabinet.
- Locate 12 black bolts from the hardware kit.
- Using 2 people, place one front section into
position. Make sure the arrows point toward the rear
of the cabinet.
- Hand thread the 6 bolts into the holes of the
connection plate.
- Using 2 people, place the other front section into
position.
- Hand thread the 6 bolts into the holes of the connection plate.
- All 12 of these bolts on both sides can now be tightened using a # 2 square bit.
A5BOPH312
A5BOHH090
A5BOHH090
19
A5WALO010
A5WAFL050
A5WALO010
A5WAFL050