Bay-Tek HOT SHOT FREE THROW FURY Manual page 48

TROUBLESHOOTING GUIDE
Problem
Tickets do not
dispense or
Wrong amount
dispensed
Check for
the correct amount of
tickets set in menu.
Menu Buttons do
not work.
The menu buttons
are located inside
the Front Door
Ensure Controller Board is
All LED Color
receiving voltage from
Strips are not
Power Distribution Board.
Working
Ensure USB cable has
good communication to the
Controller Board
motherboard.
issue
Faulty LED
Loose or bad connection.
LED Lights in
the Hoop
Backboard
are not
Working
Test LED's in Diagnostic
Menu
Faulty LED
Loose or bad connection.
LED Lights in
the Left and
Right Side
Test LED's in Diagnostic
Cage are not
Menu
Working
Faulty LED
Probable Cause
Opto Sensor on ticket
dispenser dirty.
Faulty ticket dispenser.
Notch on tickets cut too
shallow.
Faulty cable. Disconnected,
loose or broken wires.
Faulty I/O Aux Board.
Settings in Menu are
incorrect.
Swap connectors at the 2
buttons.
Pinched, broken, or
disconnected wiring
I/O Aux board faulty.
Blow dust from sensor and clean with isopropyl
alcohol.
Replace with working dispenser to isolate the
problem. (A5TD1)
Flip tickets and load upside-down to have large cut
notch toward opto sensor.
Check cables from ticket dispensers to Door board.
Check for continuity.(CE22016P and CE22017P)
Ensure issue is not with a card swipe system -
Replace I/O Aux Board. Part # AACB9605A-HSHOT2
Enter Menu and check certain areas:
Redemption Type set to Entertainment Only
Tickets settings per Point.
Door Board Dipswitch Settings:
1/2 Ticket Payout / Fixed tickets
Replace button if problem stays with button.(AAPB2700A)
Inspect crimp to ensure good connection.
Check connections from menu buttons to I/O Aux Board.
Check cables (AAPB2700A, AACE22018P)
Replace Door Board if needed. Part #
Refer to wiring diagram. Check connections & reseat cables
from Power Distribution Board to Board. CE22013P
Refer to wiring diagram. Check connections and reseat USB
cable from Motherboard to Light Board..
Cable # A5CBL5900
Refer to wiring diagram. All light cables plug into the
Controller Board.
Refer to wiring diagram. Check multiple connections and
reseat cables from Controller Board to Backboard. Cables #
CE220005P, CE22035P. CE22033P, CE22024P
And cables from Power Distribution Board # CE22006P,
CE22034P, CE22025P
Enter menu, scroll to Diagnostic Menu and press "Menu
Select" button to access color test
Replace faulty LED. Part # AACE22025P & AACE22024P
Refer to wiring diagram. Check multiple connections and
reseat cables from Controller Board to side cage lights.
Cables # CE220005P, CE22035P. CE22033P, CE22037P
Enter menu, scroll to Diagnostic Menu and press "Menu
Select" button to access color test
Replace faulty LED. Part # AACE22039P
48
Remedy
AACB9605A-HSHOT2