Bay-Tek HOT SHOT FREE THROW FURY Manual page 24

- Using 2 people, carefully carry the Back Wall Panel up the 2
ladders.
Make sure the notch cutout is on the bottom.
- Slide the bottom of the Back Wall Panel
against the red metal rails and lower into the
gap between the red metal brackets and the
bare wood back wall splice.
Picture of it fully seated into the gap.
- Locate 2 of bolts (A5SCPH270) from the hardware kit.
- Carefully climb inside the cabinet and install 1 of these bolts
into the right side of the game, in the bottom hole of the newly
installed panel as shown.
Tighten using a # 2 square bit.
- Install the other bolt into the left side of the game, in the bottom
hole of the newly installed panel.
Tighten using a # 2 square bit.
24
A5SCPH270