Power Supply Diagnostics; How To Replace Display; How To Replace Score Sensor - Bay-Tek HOT SHOT FREE THROW FURY Manual

POWER SUPPLY DIAGNOSTICS

1.) Verify AC power to game. Check power strip in front door. The rocker switch should be illuminated.
2.) Check connection to power supply.
3.) Ensure Power Supply switch is set to 115V (or 230V)
(Some model power supplies may not have this)
4.) Ensure Power switch is on.
5.) Check for power supply fan turning.
- If the power supply fan is turning and there is no 12 Volts out, the power supply is
faulty and needs to be replaced.
6.) If power supply fan is not turning, check power supply cables to the Power
Distribution Board. This board takes the power in, and directs it to the different 12 volt
loads.
- Turn off game.
- Unplug all power out connectors from the right side of the Power Distribution
Board. Turn on game and if the power supply fan is turning, plug one cable in at a
time until the fan stops turning.
- If power supply fan is not turning when only the power supply is plugged into the
Power Distribution Board, then replace power supply. It should come on with simply
the load of the Power Distribution Board plugged into it. Part # A5PS1013

HOW TO REPLACE DISPLAY

The display boards are accessed from the front of the cabinet.
Remove the screws holding the front plexi in place using a # 2
square bit.
The display board can then be lifted out and unplugged.
HOW TO REPLACE SCORE SENSORS
To change a score sensor, unplug the cable from the back of
the cabinet. A 10-12 foot ladder is needed for this.
Carefully climb into the cabinet to the hoop.
Unthread the plastic nut on the back of the sensor.
The sensor can now be removed and replaced.
60
A5PS1013
Power Supply
A5CB5156B
Power Dist. Board