4 Transmitter
3. Select
selection with SET.
4. Select
5. Press
one digit to the right using and increase value of digit by 1
using . Confirm with
6. Select
. Confirm with
7. Press
using and increase value of digit by 1 using (0 to 3600
seconds possible). Confirm with
8. Return to
9. Return to
10.Change to the other relays using or and perform settings
in the same way.
Using alarm as collective alarm or not using it at all
If an alarm is assigned to the collective alarm, the relay is switched
and a visual alarm can be issued via the display as soon as (at
least) one of the warning or error messages of the testo 6381
transmitter (or the connected testo 6610 probe) becomes active.
✓ Alarm is selected (see previous steps 1 and 2).
1. U se or to determine whether
Collective alarm
2. If collective alarm is selected: Select
Select
Alarm
3. Change to another alarm using or and perform settings in
the same way.
4. Return to
5. Continue to
Measuring Mode with ESC.
4.4.6.5.
Editing Main Menu Settings
You can edit instrument settings and other settings.
> In Measuring Mode, press SET, select
using or and confirm selection with SET.
70
(e.g. "Channel 1") with or and confirm
Channel x
Max control
or
SET
and edit
Limit value
Visual alarm
with or . Select
SET
or abort entry with ESC.
SET
and edit
Alarm
Channel x
with ESC.
Alarm x
with ESC.
The messages affecting the collective alarm can only be
selected in the P2A software, see volume 2, 7.3. Using the
software.
or
not
with or . Confirm with
YES
or
NO
x.
Main Menu Alarm
Main Menu Settings
Min control
with or (see graphic).
as well as Hysteresis: Scroll
SET
or abort entry with ESC.
delay: Scroll one digit to the right
SET
or abort entry with ESC.
Alarm x
used. Confirm selection with SET.
Visual alarm
with ESC.
with or or return to
Main Menu Settings
YES
or
NO
with or
should be used as a
with or .
SET
and return to