7 Parameterizing, adjusting and analyzing software (P2A software)
4 Function buttons: Dialogues on editing and testing the
instrument are opened by means of the buttons.
[Change parameterization]
instrument/parameter file.
[Test/analyze transmitter]
the transmitter.
[Adjusting the transmitter]
transmitter.
[Transmitter history]
5 File information:
Status
An instrument file is
selected
A parameter file is
selected
Connection status
6 Status bar: Shows the current status when editing via the menu
bar.
7.3.2.
Editing instrument/parameter file
7.3.2.1.
Changing instrument/parameter file
✓
The desired instrument/parameter file is marked.
1. Click on
-
The
dialogue is opened with the
If the parameters were transmitted from other parameter files into
the instrument file, a message is shown with which you can
transmit the new parameters to the connected instrument using
[Yes].
> If the parameters should not be transmitted, click on [No].
2. Change or enter parameters in the corresponding fields.
Field
Unit/
Analog output
see 7.3.5. Transmitter history.
Shown in the window
Type, serial number, firmware version of the
instrument.
Type, serial number and firmware version of
instrument for which the parameter file was
created.
Green = connection is active
Red = connection is inactive
[Change
parameterization].
Properties of <Instrument type> <Serial number>
Explanation
All analog outputs are parameterized in this
mask.
see 7.3.2.1. Changing
see 7.3.3. Chapter Analyzing/testing
see 7.3.4. Chapter Adjusting the
Change parameterization
register.
139