6 testo 6610 probes
6.4.1.3.
Replacing the filter/protection cap for duct versions
1. Unscrew defective filter/protection cap (2) from probe shaft (1).
2. Screw new filter/protection cap onto probe shaft.
6.4.2.
Cleaning the instrument and filter/protection cap
•
Only clean the instrument carefully with a moist cloth.
•
Do not use aggressive cleaning agents.
•
Do not use any solvents.
•
Unscrew cap or protection cap to clean, clean with compressed
air and replace. Take care not to damage the sensor!
6.4.3.
Replacing the sensor
Thanks to the probe concept (digital, plug-in), all probes can be
changed in situ within seconds if necessary, generally without any
interruption to the operation of the machine.
132
The following descriptions applies to these probes:
•
testo 6613
•
testo 6614
•
testo 6615
•
testo 6617
Do not damage the sensor when exchanging the filter/the
protection cap and do not touch its surface!
Screw on protection cap by hand, i.e. do not tighten it using
a tool.
To maintain the extremely high accuracy of the testo 6610
probe, it is not possible for customers to change the sensor.
Please contact your Testo Service team for this.