About Battery, Adapter And Firmware Upgrade - ADInstruments S7200 Operation Manual

AD INSTRUMENTS S7200 TV Signal Analyzer Operation Manual

1.2. About Battery, Adapter and Firmware upgrade

Please charge-discharge the battery in every 3 months to extend battery life!
Warning： Danger of explosion if the battery is incorrectly replaced. Replace only
with the same type battery recommended. Do NOT dispose of batteries in a fire.
Do NOT place batteries in the trash. Batteries must be recycled or disposed of
properly.
CAUTION: Recharge the battery only in the instrument. If left unused, a fully
charged battery will discharge itself over time.
Never use a damaged or worn-out adapter or battery. Charging the batteries
internally, even while the analyzer is powered off, the analyzer may keep warm.
To avoid overheating, always disconnect the analyzer from the AC adapter before
storing the analyzer into the soft carrying case.
CAUTION: Connect the automotive adapter to the power output connector for IT
equipment, when charging the battery on your automotive.
CAUTION: Temperature extremes will affect the ability of the battery to charge.
Allow the battery to cool down or warm up as necessary before use or charging.
Storing a battery in extreme hot or cold temperatures will reduce the capacity and
lifetime of a battery. Battery storage is recommended at a temperature of less
than 25°C.
The analyzer cannot be used in the standard soft carrying case for more than 1
hours if the ambient temperature is higher than 35°C.
CAUTION: Use only the original AC-DC adapter or originally supplied battery for
the power source.
Whether the instrument work or power off, you can charge the battery.
1 Insert the battery in the analyzer.
2 Plug in the AC-DC adapter and switch on the external power.
2