Satcr Control Signal - ADInstruments S7200 Operation Manual

AD INSTRUMENTS S7200 TV Signal Analyzer Operation Manual

5.6.3. SaTCR Control Signal

SaTCR protocol is DiSEqC protocol extension. The SaTCR allow satellite STB control
coaxial cable connected external device. The SaTCR protocol make the STB has the
ability to control LNB which based on SaTCR standard.
In SaTCR control interface, user can tap on one command item, the screen will
display command running information:"Send command ......","Send command
OK!". When system sent SaTCR command, any keypad operation is forbidden. If
the icon behind the one command item, this means user can and
modify command parameter value, as the Figure 5-72 show.
Figure 5-72 SaTCR Control Signal Configure Interface
SaTCR protocol control command transmission need S7200 power supply status
enable. When power supply off or other external device power supply, this
function doesn't take effect.
SaTCR setup interface display 8 channel, all these 8 slots' frequency can edit, the
frequency range is 950~2150MHz.
101