Inspect Safety Labels; Keep Work Area Clean; Keep Work Area Well Ventilated; Use Proper Eye And Face Protection - Textron JACOBSEN Eclipse 2 Technical/Repair Manual

Table of Contents

Advertisement

Inspect Safety Labels

Safety decals are critical to the safe operation of the
mower. Inspect the mower for any damaged, missing, or
unreadable decals. Replace decals as needed before
placing the mower back into service.

Keep Work Area Clean

A clean, organized, well-lit work area is important to
promote safe working conditions.
• Keep floor clean of debris and clear of parts and
tools.
• Clean up any spilled fuel, oil, and/or chemicals
immediately.
• Store all air hoses and electrical cords properly when
not in use.

Keep Work Area Well Ventilated

!
WARNING
Never operate the engine without proper
ventilation; exhaust fumes can be fatal if inhaled.
Certain test and adjustment procedures require the
engine to be running. Be sure work area is well
ventilated; never run the engine in an enclosed area.
Use Proper Eye and Face
Protection
!
WARNING
Always use approved personal protection
equipment. Avoid workplace hazards by wearing
properly maintained, approved eye and face
protection. Failure to use appropriate protection
equipment may result in death or serious injury.
Always wear eye protection while in a shop environment.
• Safety Glasses: Safety glasses offer a minimum level
of protection from flying debris.
• Face Shields: Face shields are often used along with
safety glasses to offer a higher level of protection
when sparks and flying debris are present.
• Vented Goggles: Goggles offer side protection not
offered by safety glasses alone.
• Unvented Goggles: Unvented goggles offer
protection from chemical splashes and vapors.
4262930-Rev A

Park Mower Safely

Battery Pack Models

See Figures 1-5 through 1-7.
!
WARNING
Before cleaning, adjusting, or repairing this
equipment, disengage mow switch, engage park
brake, move key switch to the off position, and
remove key to prevent injuries.
When performing maintenance other than
adjustments that require the reel and/or traction
motors to be running, disconnect the battery
pack plug to prevent accidental motor
engagement and bodily injury.
1
4
Figure 1-5
1. Release the Operator Presence Control (OPC)
bail (2).
2. Engage the park brake lever (4).
3. Disengage the mow switch (1).
4. Move key switch (3) to the off position and remove
key.
SAFETY
1
2
3
TN4388
1-5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JACOBSEN Eclipse 2 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Jacobsen 118fJacobsen 122f

Table of Contents