Inspect Safety Labels; Keep Work Area Clean; Keep Work Area Well Ventilated; Use Proper Eye And Face Protection - Textron Jacobsen InCommand PGM 22 Technical/Repair Manual

SAFETY

Inspect Safety Labels

Safety decals are critical to the safe operation of the
mower. Inspect the mower for any damaged, missing, or
unreadable decals. Replace decals as needed before
placing the mower back in service.
1

Keep Work Area Clean

A clean, organized, well lit work area is important to
promote safe working conditions.
• Keep floor clean of debris and clear of parts and
tools.
• Clean up any spilled fuel, oil, and/or chemicals
immediately.
• Store all air hoses and electrical cords properly when
not in use.

Keep Work Area Well Ventilated

!
Never operate the engine without proper
ventilation; exhaust fumes can be fatal if inhaled.
Certain test and adjustment procedures require the
engine to be running. Be sure work area is well
ventilated; never run the engine in an enclosed area.
Use Proper Eye and Face
Protection
!
Always use approved personal protection
equipment. Avoid workplace hazards by wearing
properly maintained, approved eye and face
protection. Failure to use appropriate protection
equipment may result in death or serious injury.
Always wear eye protection while in a shop environment.
• Safety Glasses: Safety glasses offer a minimum level
of protection from flying debris.
• Face Shields: Face shields are often used along with
safety glasses to offer a higher level of protection
when sparks and flying debris are present.
• Vented Goggles: Goggles offer side protection not
offered by safety glasses alone.
• Unvented Goggles: Unvented goggles offer
protection from chemical splashes and vapors.
1-6
WARNING
WARNING

Park Mower Safely

See Figures 1-3 through 1-6.
!
WARNING
Before you clean, adjust, or repair this
equipment, disengage all drives, engage parking
brake and stop engine to prevent injuries.
Whenever performing maintenance other than
adjustments that require the engine to be
running, remove the spark plug wire and place
the wire away from the plug to prevent accidental
starting and bodily injury.
2
1
Figure 1-3
1. Release the Operator Presence Control (OPC) bail
(2).
2. Engage the park brake lever (1).
3
Figure 1-4
3. Move engine on/off switch (4) to OFF position.
4. Close fuel shutoff valve (3).
TN0014
4
TN0015
4157082 First Edition