Textron JACOBSEN Eclipse 2 Technical/Repair Manual page 191

Bearing Adjustment
See Figure 10-3.
1. Park the mower safely. (See "Park Mower Safely" on
page 1-5.)
5
4
3
2
1
6
Figure 10-3
2. Remove screw (1), lock washer (2), flat washer (3),
and guide wheel (4) from the motor side of the cutting
unit.
3. Loosen turf groomer lock nut (8), shaft screw (6), and
front roller lock nuts (5) on the motor side of the
cutting unit.
10
9
11
9 12
Figure 10-4
4262930-Rev A
4. Tighten turf groomer bracket screws (9) and carriage
bolt (12) on both sides of the cutting unit to close the
gap between the turf groomer brackets (11) and
frame (10). The turf groomer brackets should be
parallel tot he frame and allowed to pivot freely.
5. Adjust turf groomer lock nut (8) to make contact with
spacer (7). Tighten shaft screw (6).
6. Align the turf groomer blades to the roller discs. (See
"Blade-to-Roller Alignment" on page 10-7.)
7. Adjust turf groomer belt. (See "Belt Adjustment" on
page 10-6.)
8
7
TN4549
TN4551
ACCESSORIES
10
10-5