Moving The Rotation Arm To The Specified Angle - Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist

Saturn DigiSizer II 5205

Moving the Rotation Arm to the Specified Angle

1. If the Instrument Schematic is not shown on the computer screen, select Unit[n] > Show
instrument schematic.
2. Select Unit[n] > Enable manual control.
3. Right-click on the rotation arm symbol and select Move.
4. Select Angle and type 65 in the degrees field.
5. Click OK
6. After the arm stops moving, 65.000 will display to the upper right of the rotation arm on
the schematic.
Jul 09
; the rotation arm will start to move.
Verifying Operation
69