Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist page 31

Saturn DigiSizer II 5205
3. Pull the voltage selector card straight out of the power connector housing.
4. Orient the voltage selector card so that the desired voltage is indicated at the bottom.
Orient the indicator pin so that it points upward as shown in the following illustration.
Indicator Pin
Voltage
5. Insert the voltage selector card into the power connector housing with the edge containing
the desired voltage first and with the printed to the left.
6. Fuse the input power line according to local safety practices. The input power connector
can be used with either a single-fuse arrangement or a double-fuse arrangement.
a. If the single-fuse arrangement is desired, position the fuse block so that the side with
the single-fuse slot and the jumper bar is away from the cover.
If the double-fuse arrangement is desired, position the fuse block so that the side with
the double-fuse slots is away from the cover.
Jul 09
Printed Side
Setting up the DigiSizer System
25