Table of Contents
Advertisement
Appendix C
3.
Pull the voltage selector card straight out of the power connector housing.
4.
Orient the voltage selector card so that the desired voltage is indicated at the bottom.
Orient the indicator pin so that it points upward as shown in the following illustration.
Indicator Pin
Voltage
5.
Insert the voltage selector card into the power connector housing with the edge containing
the desired voltage first and with the printed side to the left.
The power cord must be disconnected from the instrument when installing or
replacing fuses. Failure to disconnect the power cord could result in electrical
shock.
C-2
Saturn DigiSizer II 5205
Printed side
of card
Jul 09
Advertisement
Table of Contents
Need help?
Do you have a question about the Saturn II 5205 DigiSizer and is the answer not in the manual?