Table of Contents
Advertisement
Setting up the DigiSizer System
The fuses used in the equipment must be identical in type and rating to that specified.
Use of other fuses could result in electrical shock and/or damage to the equipment.
b. Insert appropriate fuse(s) for the input power source. Refer to the chart below for the
appropriate fuse rating.
Power Source
100-120 VAC
200-240 VAC
7. Insert fuse block into the input power connector (as shown in the following illustration)
and snap it into place, then close the cover. Once the fuse block and cover are in place, the
position of the indicator pin shows the input power selected.
26
Fuse
2.0 Amp (slow-blow)
1.0 Amp (slow-blow)
Saturn DigiSizer II 5205
Jul 09
Advertisement
Table of Contents
Need help?
Do you have a question about the Saturn II 5205 DigiSizer and is the answer not in the manual?
Questions and answers