Table of Contents
Advertisement
Saturn DigiSizer II 5205
• Connect the analyzer to the configured port and turn the analyzer on.
Install the program as follows:
1. Turn on the analyzer and the liquid sample handler.
2.
Insert the Saturn DigiSizer CD into the CD-ROM drive.
3.
Select Start > Run from the Windows menu bar.
4.
Enter the drive designator for the CD-ROM, followed by setup. For example: e:setup
Alternatively, you can click
setup.exe.
5.
Click
OK;
that should be completed before installing the software.
If all of the steps have not been completed, click
restart the installation program. Do not proceed with installation until these tasks have
been completed.
Jul 09
Browse
the Ethernet Introduction dialog is displayed. This screen outlines the steps
, navigate to your CD-ROM drive, and select
Cancel
and perform the steps; then
Installing the Analysis Program
45
Advertisement
Table of Contents
Need help?
Do you have a question about the Saturn II 5205 DigiSizer and is the answer not in the manual?