Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist page 46

Setting up the DigiSizer System
4. Insert the remaining piece of flexible tubing through the hole provided on the base of the
sample handler.
5. Guide the tubing through the hole in the front chassis (just below the rinse pump) and
connect it to the remaining barbed fitting of the T-connector.
6. Install the other end of the flexible tubing onto the sample transfer tubing connector on the
side chosen in Step 5 of
Make sure the side to which you connect the flexible tubing coincides with the one
chosen in the arm of the MasterTech.
7. Replace the cover of the liquid sample handler. Replace the retaining screws on the right
side of the unit and retighten the thumb screw on the rear panel.
40
Barbed connector
"Installing Sample Transfer Tubing" on page 36
Saturn DigiSizer II 5205
MasterTech Flexible tubing
.
Jul 09