Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist page 117

Saturn DigiSizer II 5205
Appendix C: Selecting the Voltage and Installing Fuses with
On some instruments, the input power connector has a removable cover instead of the hinged
cover desribed in this document. If this type of configuration is used on the instrument being
installed, follow the instructions below.
The power cord must be disconnected from the instrument before removing the
cover from the input power connector. Failure to disconnect the power cord could
result in electrical shock.
1. Make sure the power cord is not connected to the instrument.
2. Check the voltage setting on the rear panel of the instrument.
• If the voltage is correct:
a. Using a pointed object, remove the fuse block and cover assembly from the power
connector at the rear of the instrument. (The illustrations below represent a typical
instrument.)
b. Proceed to Step 6.
• If the voltage is incorrect, remove the fuse block cover as described above, then proceed
to Step 3.
Jul 09
Other Input Power Configuration
Appendix C
1
C-