Installing The Analysis Program; Entering Ethernet Settings; Configuring The Firewall Setting; Installing The Software - Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist

Installing the Analysis Program

Installing the Analysis Program
This section includes instructions for configuring the ethernet connection, configuring the
firewall setting, and installing either the Saturn DigiSizer 5205 Standard analysis software or
the Saturn DigiSizer 5205 confirm analysis software. Follow the software installation
instructions for the type of system purchased by the customer.
All programs should be closed before beginning installation of the Saturn DigiSizer
software.

Entering Ethernet Settings

The computer and analyzer communicate by means of an ethernet connection. Before
installing the Micromeritics software, you must check the ethernet settings in the Microsoft
operating software and correct if necessary. The ethernet settings are as follows:
IP address field: 192.168.77.100
Subnet mask field: 255.255.255.0
If you need detailed instructions for performing this procedure, refer to Technical Bulletin
Gen034.

Configuring the Firewall Setting

An ethernet firewall typically is enabled by default for the Windows XP and Windows Vista
operating systems. Windows operating systems prior to these versions did not have firewalls.
To prevent an initialization failure when running the Micromeritics software, you must turn off
the firewall option between the computer and the analyzer. (Refer to Technical Bulletin
Gen034 for details.) You must also do this for any third-party firewalls that may have been
installed (refer to the firewall software manual or contact the system administrator for
instructions).

Installing the Software

Be sure you have completed the following tasks before installing the software for the first
time.
• Configure the ethernet port the analyzer will use.
• Disable the firewall setting for the connection between your computer and analyzer.
44
Saturn DigiSizer II 5205
Jul 09