Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist page 22

Setting up the DigiSizer System
7. Unpack the sample cell holder and attach it with the two screws provided.
If the rotation arm is blocking access to the sample cell holder location, do not
attempt to move it. The arm is controlled through the DigiSizer software.
Instructions are provided for moving the arm after the software is installed. (Refer
to "Moving the Rotation Arm to the Specified Angle" on page 69.)
If this is the case, do not install the sample cell holder until you have moved the
rotation arm using the software.
8. Remove the plugs from the ports on the inside, right side of the analyzer to allow
installation of the sample transfer tubing.
9. Place the liquid sample handler to the right side of the analyzer.
16
Saturn DigiSizer II 5205
Sample cell holder
Attach with the two phillips-head
screws provided
Jul 09