Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist page 61

Saturn DigiSizer II 5205
17. Click Next
18. Choose one of the following:
If....
the port you plan to
use is listed:
the port you plan to
use has been config-
ured but is not listed:
19. Click Next
If you selected zero (0) as the number of instruments to install, the Calibration dialog
is not displayed.
The calibration files may be on another disk. In this case, you will be prompted to
insert the disk containing the calibration files into the CD drive.
20. Click
Next
displayed. Use the scroll bar if you wish to read the contents of the file, then click
to close the dialog.
21. Remove the Setup CD and store in a safe place. The original Setup CD contains the
calibration files specific to your instrument. Upgrade CDs do not contain calibration files.
Therefore, it is important that you maintain your original Setup CD in a secure location in
the event calibration files need to be reinstalled.
Jul 09
; the Ethernet Ports dialog is displayed.
Then....
select the port and proceed to the next step.
Click
Specify
displayed.
Enter the remaining portion of the IP address in the
enabled fields, then proceed to the next step.
; the calibration files are installed.
. The Installation Complete dialog box containing the Readme file is
Installing the Analysis Program
, the Specify Ethernet Port dialog is
Finish
55