Turning On The Mastertech (If Used) - Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist

Saturn DigiSizer II 5205

Turning on the MasterTech (If Used)

1. Make sure the proper operating voltage and fuse are selected and in place.
2. Insert the power cord into the connector on the rear panel of the MasterTech and into an
appropriate power source.
3. Place the POWER ON/OFF switch, located on the MasterTech rear panel, in the ON ( | )
position. The +5 and +24 LEDs on the rear panel and some of the LEDs in the front panel
switches should illuminate.
Power On/Off Switch
The ultrasonic probe should not be turned on at this point. Observe the indicator on
the ULTRASONIC PROBE AUTO/ON switch on the front panel of the MasterTech
(shown in the following illustration). If the indicator below ON is illuminated, press the
switch to turn off the probe. The indicator below AUTO should illuminate.
4. Press the ARM AUTO/LOAD switch on the front panel of the MasterTech. The arm
should rise to the Load position, which is used for removal and replacement of the tray.
Jul 09
+5 and +24 VDC Indicators
RS232 Connector
Power Display
Ultrasonic Probe
Auto/On Switch
Setting up the DigiSizer System
Pump Auto/Off
Switch
Intensity Control
Arm Auto/Load
Switch
33