Selecting The Computer Line Voltage; Connecting Cables - Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist

Setting up the DigiSizer System

Selecting the Computer Line Voltage

The line voltage of the computer must be set to match the input power source (from the wall
outlet). The computer operates with either 100-120 VAC or 200-240 VAC at 50 or 60 Hz.
Refer to the instruction manual supplied with your computer for instructions on selecting
power input.
Do not connect the computer power cord to a power source until the proper voltage
selection is made. Doing so could result in electrical shock and/or damage to the
computer.

Connecting Cables

Ethernet Cable
The Ethernet cable has RJ45 connectors (similar to a phone jack). Either a straight-through
patch cable or a crossover cable can be used. Install the cable as follows:
1. Insert one end of the Ethernet crossover cable into the connector labeled Ethernet on the
rear panel of the analyzer.
2. Insert the other end of the cable into the RJ45 connector on the ethernet card (exposed on
the rear panel of the computer).
12
Saturn DigiSizer II 5205
Jul 09