Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist page 17

Saturn DigiSizer II 5205
4. Orient the voltage selector card so that the desired voltage is shown on the side of the card
facing you.
5. Slide the voltage selector card into the power connector housing and press until it fits
securely.
The fuses used in the instrument must be identical in type and rating to that specified.
Use of other fuses could result in electrical shock and/or damage to the instrument.
6. Insert the appropriate fuses into the fuse block. Refer to the chart below for the appropriate
fuse rating.
Power Source
100 - 120 VAC
220 - 240 VAC
7. Slide the fuse block into the housing and press until it fits securely.
Jul 09
Fuse
Two 5x20mm, SLO-BLO, 1.6A
Two 5x20mm, SLO-BLO, 1.25A
Setting up the DigiSizer System
Voltage
setting
11