Installing The Beaker Tray - Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist

Saturn DigiSizer II 5205

Installing the Beaker Tray

1. Place the POWER switch in the ON position.
2. Make sure the arm of the MasterTech is in the LOAD (uppermost) position; the LOAD
LED will be illuminated. If the LED is not illuminated, press the ARM AUTO/LOAD
switch.
3. Hold the tray firmly by the outside edge. Notice that the bottom of the tray has small slots
positioned radially outward from the inside edge. Place the tray on the MasterTech so that
the arm passes through the center opening of the tray.
4. Make sure the drive pin is lined up into a radial slot on the bottom of the tray. The position
of the tray does not matter at this point.
Jul 09
Setting up the DigiSizer System
35