Verifying Operation; Entering Service Test Mode; Exiting Service Test Mode - Micromeritics Saturn II 5205 DigiSizer Installation Instructions And Checklist

Verifying Operation

Verifying Operation
Installation of the Saturn DigiSizer system is now complete. It is important to perform a series
of checkout procedures to verify proper operation. These procedures are designed to assist you
in verifying that all installation procedures were performed properly and that the Saturn
DigiSizer and its peripheral equipment are working properly. If two analyzers are installed,
perform the procedures in their entirety on each one. These procedures should be performed
following installation, and may be performed following any subsequent equipment repairs,
replacements, or relocation.

Entering Service Test Mode

The Saturn DigiSizer 5205 Analysis Program must be run in Service Test Mode to perform
some of the verification procedures. To enter Service Test Mode:
1. Select Options > Service Test Mode to display the password dialog.
2. Enter the service password, then click OK.
Service Test Mode remains enabled until you exit it or until the application is closed.

Exiting Service Test Mode

Perform all operational verification tests in Service Test Mode. When you have finished
operational verification, select Options > Service Test Mode to remove the checkmark and
exit Service Test Mode
66
Saturn DigiSizer II 5205
Jul 09