Christie CP2420-Xe Service Manual page 111

8. Carefully remove the light sensor board from the housing and disconnect the light sensor
harness connector (LSM).
9. To re-install, follow these steps in reverse order.
10. After powering on the projector, re-calibrate the light sensor module (minimum/maximum
footlamberts).
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Printed circuit boards and sensors
111